ISM Band Wireless Data Link Antennas, 2.4 to 2.5 GHz Full Band
Z2400-8 Mast Mount Collinear Antenna, 10 dBi gain
Z2400-8 is an omnidirectional collinear mast mount antenna designed for data communications in the 2.4 to 2.5 GHz ISM band. 85 cm tall, the antenna delivers 10 dBi gain.
Construction consists of copper internals, a robust white fibreglass radome and stainless steel mount tube.
An N-Female connector rated for up to 50 watts input power is located at the base of the mount tube.
One UB3SS stainless steel parallel clamp will be ideal for mounting this collinear antenna to a round mast up to 50 mm in diameter.
High quality RU400 low loss 50 ohm feeder cable, connectors and other installation accessories can be supplied as you require.
Z2400-8RS Mast Mount Collinear Antenna with Rear Reflector Screen, 13 dBi gain
Z2400-8RS is a collinear mast mount antenna designed for wireless data link applications across the 2.4 to 2.5 GHz ISM band. The reflector screen restricts the radiation pattern emitted at the rear.
85 cm tall, the antenna delivers 13 dBi forward gain with the rear screen fited.
The front-to-back ratio is -20 dB.
Construction consists of copper internals, a robust white fibreglass radome, stainless steel mount tube and stainless steel rear reflector screen.
An N-Female connector rated for up to 50 watts input power is located at the base of the mount tube.
Two U-bolts are supplied for mounting the antenna to a round mast between 20 mm and 50 mm in diameter.
Signal loss will be high at ISM band data link frequencies. It is therefore most important to select a good quality low loss feeder cable according to the length of run required. Always keep the cable run to the shortest length necessary. RU400 low loss is recommended as the minimum standard of feeder cable necessary to reduce signal loss and maintain optimum antenna performance.
SG2400 Stud Mount and Flange Mount Collinear Antennas, 5.14 dBi gain
These omnidirectional collinear ISM band data link antennas deliver 5.14 dBi gain and are available in either stud mount or flange mount models.
SG2400TPM stands 55 cm tall and mounts simply into any bracket with 12.7 mm (½") minimum diameter hole using the stainless steel nut and washer at the base.
SG2400R has a PVC flange designed for mounting to the roof, floor or other flat surface using 2 screws. The antenna stands 38 cm tall.
Both models are supplied with 50 cm of RG58 low loss solid core cable and a TNC Male connector fitted as standard. Connectors other than TNC can be supplied as required.
At data link 2.4 GHz frequencies, it is important to keep feeder cable runs to the shortest length necessary. Where a long run is unavoidable, then a high quality low loss cable such as RU400 should be used.
MD2400 Stud Mount Collinear Antennas, 2.1 dBi gain
These ground independent omnidirectional collinear data link antennas cover the full ISM band 2.4 to 2.5 GHz and deliver 2.1 dBi gain. Standing just 23 cm tall, they mount simply into any bracket with 12.7 mm (½") minimum diameter hole.
Model MD2400-B has a Black radome and MD2400-W is White.
Construction consists of brass internals, aluminium ferrule and a fibreglass radome.
5 metres of RG58 low loss cable side exits from the aluminium ferrule. An SMA Male connector is fitted to the cable.
The GM1 stainless steel ‘L’ bracket is supplied for mounting. Secure this bracket in position with 2 screws or bolts.
If the SMA Male connector or bracket supplied do not suit your particular application, other options are available upon request.