UHF Mobile Antennas with Stainless Steel Whip, 2.1 dBi gain
Model GRMWFC477, 470 to 490 MHz full band
GRMWFC477 is a ground independent, half wave, end fed mobile antenna factory tuned to cover the full UHF frequency range 470 to 490 MHz. The stainless steel whip with phasing coil stands 65 cm tall and delivers 2.1 dBi gain.
The stainless steel, delrin, copper and brass construction provides an extremely robust and durable antenna capable of surviving the harshest of conditions and treatment.
The lightweight design makes this antenna suitable for mounting in any position on a vehicle such as the bull bar or guard, the boot of a sedan or to a truck mirror.
Secure the antenna into any bracket with a minimum 10 mm diameter hole using the nut and washer on the threaded base.
4.5 metres of RG58 stranded cable bottom exits through the mounting base. The cable is fixed into the base, so the antenna top cannot be removed.
An FME female connector is fitted to the cable.
A FME Male to UHF Male adaptor is included in the kit to provide another common connector option.
Model GRUFC, 420 to 520 MHz, specify any 15 MHz bandwidth
The GRUFC ground independent UHF mobile antenna is a half wave, end fed design ideally suited for mounting to a vehicle bull bar or guard, the boot of a sedan or a truck mirror using the appropriate bracket.
Specify any 15 MHz bandwidth within the UHF frequency range 420 to 520 MHz and your antenna will be factory tuned accordingly to better than 1.5:1 VSWR.
The antenna stands 1.1 metres tall and delivers 2.1 dBi gain. The stainless steel whip with delrin, copper and brass ferrule will survive harsh conditions and rough treatment.
4.5 metres of RG58 low loss stranded cable bottom exits through the mounting base. The cable is fixed, so this option is ideal when a detachable antenna top is not desirable.
An FME female connector is fitted to the cable.
To provide another common connector option, an FME Male to UHF Male adaptor is included in the antenna kit.
Secure the antenna into any bracket with minimum 10 mm diameter hole using the nut and washer on the threaded base.