3G Network Cellular Mobile Phone Antennas, 1920-2170 MHz
The SGL2000 antenna is designed for the 3G cellular mobile phone network operating at 1920–2170 MHz. With 6.2 dBi gain, the antenna will deliver consistent and dependable results with maximum efficiency, particularly where signal strength is marginal.
The spring and fibreglass radome stands 48 cm tall. The antenna mounts into any 16 mm hole and is secured firmly by the threaded stud and nut assembly provided.
A range of brackets are available to suit various mounting positions such as a vehicle bull bar, guard, boot or truck mirror.
The model OGI-08-4 antenna sticks to the inside of a vehicle windscreen and will improve cellular mobile phone reception and transmission range while travelling.
With performance comparable to an external on-glass mount whip, this antenna offers multiband coverage of all the cellular mobile phone networks operating around Australia; NEXT G, GSM and 3G combined.
Installation has never been simpler; just peel and press the adhesive pad to the inside of the screen, route the cable and connect to the car kit. No bracket, no holes, no screws ! The antenna is secure inside your vehicle.
To improve your reception of the 3G network at home or in the office, the directional mast mount Yagi model Y2009 with 11.3 dBi gain is an effective antenna solution.
SGL2000 : 3G Super Gain Light, 6.2 dBi
•
Covers the 3G network, 1920-2170 MHz full band
•
6.2 dBi gain
•
48 cm tall, lightweight design
•
5 metres of RG58 low loss cable bottom exits through electropolished stainless steel spring
•
FME female connector supplied,
not fitted
•
Secure into any 16 mm hole using the threaded stud and nut assembly supplied
•
Specify either a BLACK, WHITE or BROWN radome colour when ordering
OGI-08-4
On-Glass Inside Vehicle Mount
Multiband NEXT G, GSM and 3G
Cellular Mobile Phone Antenna
•
Covers all the cellular mobile phone networks operating around Australia;
NEXT G, GSM and 3G combined
•
2.1 dBi gain, comparable performance to an external on-glass mount whip
•
Small and inconspicuous
•
Simple installation, no bracket, no holes, no screws. Just peel and press the adhesive pad to the inside of the front or rear screen, route the cable and connect to the car kit.
•
The antenna is secure inside your vehicle. No external parts means the possibility of damage and vandalism are minimised and the car wash no longer a worry !
•
115 mm long x 21 mm wide x 7 mm thick
•
Alcohol wipe to clean and prepare glass
•
3 metres of RG174 cable with SMA Male connector fitted
