The MAGM90T series portable indoor antennas with magnetic base deliver 5 dBi gain and will enhance the reception of your wireless internet modem.
Alternatively, they can also be connected to a cellular mobile phone.
Ideal for indoor use, the magnetic base adheres to any flat metal surface. Easy to set-up, easy to remove and the detachable whip makes the antenna easy to store when not required.
These compact portable antennas stand just 32.5 cm tall and are factory tuned for better than 1.5:1 VSWR across the full band.
The 4 cm diameter magnetic base is manufactured from moulded plastic with nickel plated brass fittings. An FME Male connector is housed inside the base. The black powder coated detachable stainless steel whip fits onto the 6 mm – 26 TPI thread.
The antenna is supplied with a 5 metre RG58 low loss solid core cable set with connectors fitted.
Other connector options can be provided by special order.
Reception indoors will vary depending upon the antenna location. Best results will be obtained by positioning the antenna near to the window or outer wall, rather than in the centre of the building. If you are in a fringe reception area some distance away from the signal source, then consider our range of mast mount Base Station Cellular Mobile Phone Antennas here »
Manufactured from moulded plastic with nickel plated brass fittings, the MAG-CDMA antenna may be used to improve reception of the NEXT G cellular mobile phone network operating in the frequency range 825 to 890 MHz.
This compact portable model delivers 3 dBi nominal gain. An FME male connector is located inside the base and the magnetic base mounts simply onto any metal surface.
The antenna is easy to fit, easy to remove and at just 13.5 cm tall, easy to store when not required.
A cable set can be assembled to meet your specific requirements.
Here is the perfect choice for hire cars, or when driving different vehicles in a fleet.
The MGB-XB magnetic antenna base is manufactured from steel with an attractive polished black powder coat finish. 10.5 cm in diameter, the strong magnet will positively secure the antenna base to any flat metal surface with no slippage.
This base is designed for mounting either the M90T(Next G) or M90T(GSM) stainless steel whip, both offering 5.1 dBi gain.
Most typically, MGB-XB is used on the roof of a vehicle and removed when not required. The PVC matted pad on the bottom will prevent scratching the surface to which the base is applied.
4.7 metres of RG58 low loss solid core cable side exits from the base. The cable may be cut shorter if desired. A variety of connectors are available as you may require.